jamesinc
WD-40 Enthusiast
- Joined
- Dec 28, 2010
- Location
- Sydney, Australia
I'm referring to part #26 below. It's mounted to the back of the block (so the sensor faces the flywheel/flexplate) on the exhaust side, and has a diagnostic connector attached to the valve cover.
I'm looking for information on the tool that you connect to it and how I might make such a tool.
Edit: for reference (and future Googlers) the part # is 1219678.
I'm looking for information on the tool that you connect to it and how I might make such a tool.
Edit: for reference (and future Googlers) the part # is 1219678.
Last edited: