View Single Post
Old 09-29-2021, 10:40 AM   #30
cwdodson88
Board Member
 
Join Date: Oct 2011
Location: The Dalles, Oregon
Default

Quote:
Originally Posted by blakemcelroy2000 View Post
Ah, I see. I guess Ill just have to check if I have those. Reading online about the M rods, they look a lot stronger but also heavier. Is the "big end" rod bearing the same diameter as the 6 bolt rod end? Basically, is it possible to run M rods on a 6 bolt crank and then 24mm wrist pin pistons up top? Seems like from what Im reading online there is some serious machining that needs to take place to run this set up.
There’s not. But there is a lot to consider when trying to make 3x HP levels of anything. 2x is easy, 3x is a lot harder.
__________________
Quote:
Originally Posted by mikep View Post
Build it, break it, build what broke stronger, lather, rinse, repeat.

The Build Thread
SVEA - PUSHROD TURBO!
cwdodson88 is offline   Reply With Quote